4.10. Removal of a cover of the pump of cooling liquid

 PERFORMANCE ORDER

We merge cooling liquid (see Replacement of cooling liquid).
It is more difficult to carry out work on dismantle of a cover on the carburetor engine therefore all operations are shown on it.
We remove a fan casing (see Removal of a casing of the fan of the carburetor engine).
We take off a belt of the drive of the pump of cooling liquid (see Adjustment of a tension and replacement of a belt of the drive of the pump of cooling liquid).

Head "on 13" we turn off three bolts of fastening of a krylchatka and a pulley of the pump of cooling liquid.

We remove a washer...

... krylchatka...

... and pulley.

We disconnect fastening of the generator to a tension level (see Adjustment of a tension and replacement of a belt of the drive of the pump of cooling liquid).

Head "on 17" we turn off a nut of fastening of a tension level to a cover of the pump of cooling liquid.

We remove a tension level.

Head "on 13" we turn off four nuts of fastening of an arm and a cover of the pump of cooling liquid.

We remove an arm...

... and cover of the pump of cooling liquid.

The joint of a cover and pump housing of cooling liquid is condensed with laying.

We remove a pump housing of cooling liquid at repair of the engine (see Dismantling and assembly of the engine).
We make installation of a cover of the pump of cooling liquid upside-down.
At the same time for simplification of installation of a pulley, a krylchatka and a washer...

... we roll a hairpin of M8 about 40 mm long in a pulley nave.

We put on all details a hairpin and a ledge of a nave of a pulley...

... nazhivlyay two bolts also we replace a hairpin with a bolt.