3.17. Removal of a gear wheel of the drive of the oil pump

 PERFORMANCE ORDER

On the vpryskovy engine for access to a nest of the block of cylinders through which the gear wheel of the drive of the oil pump is dismantled it is necessary to remove an ignition module arm.
For this purpose...

... a key "on 13" we weaken two nuts of the lower fastening of an arm to the block of cylinders (for descriptive reasons operation is shown on the removed engine).

Head "on 13" we turn off a nut of fastening of "mass" wires of system of injection to a hairpin of the block of cylinders (in a forward top part of the block on the left side).

We remove the plug of wires from a hairpin.

Head "on 13" we turn off a nut of the top fastening of an arm of the module of ignition to the block of cylinders.

We remove an arm of the holder of a tube of a supply of oil to a hydraulic natyazhitel of a chain of the drive of the camshaft.

We lift an arm with the module of ignition and we take away it from the block of cylinders.

We hook the screw-driver a clamp of a gear wheel of the drive of the oil pump...

... also we take it from a nest of the block of cylinders.

Connection is condensed with rubber and paronitovy laying.

We insert with a tightness a wooden conical mandrel into a shlitsevy opening of a gear wheel of the drive of the oil pump...

... also we take a gear wheel from the block of cylinders, turning it counterclockwise.

Be careful, do not drop a gear wheel in the block of cylinders.

We establish a gear wheel of the drive of the oil pump upside-down.
We enter a gear wheel into gearing with a gear wheel of the roller of the drive of the oil pump...

... and holding the screw-driver a gear wheel, we take out a wooden mandrel.

Dismantle of a gear wheel of the drive of the oil pump on the carburetor engine is similar to its removal on the vpryskovy engine except that instead of a gear wheel clamp, it is necessary to remove the ignition sensor distributor (see Removal of the sensor distributor of ignition).