23.6. Removal of a box of airinflow, casing of a radiator, flexible drafts of the drive of a heater and arm of control levers heater

 PERFORMANCE ORDER

We remove a heater radiator with the crane (see Removal of a radiator of a heater with the crane).

In salon a head "on 10" we turn off four nuts of bolts of fastening of a box of airinflow and a casing of a radiator, …

… at the same time the assistant holds bolts in a motor compartment a key "on 10".

We take out bolts.

We remove an airinflow box.

Connection of a box of airinflow with a body is condensed with laying from the foam rubber pasted to an airinflow box flange.

In salon we lower a radiator casing.

Flexible draft of control of the airinflow gate does not allow to remove a radiator casing.

By the screw-driver it is hooked a clamping bracket of a cover of draft …

… also we remove a bracket.

We disconnect draft from the gate lever.

If necessary it is similarly disconnected …

… draft of the gate of heating of a windshield.

For removal of an arm of control levers a heater we unscrew screws of fastening of an arm to the dashboard (see Removal of the dashboard) and we take away an arm down.

By finger it is hooked a clamping bracket of a cover of draft …

… also we remove it.

We bring draft out of a lever opening.

Having disconnected all three drafts from an arm of control levers a heater, we remove it.
For removal of draft of the crane of a heater …

… we bring her because of the case of a ware box (the dashboard is for descriptive reasons removed).

Assembly is carried out in the return sequence. We provide completeness of opening and closing of gates and the crane of a heater, choosing places of fastening of covers of drafts as brackets.


Useful tips

Check of serviceability of a radiator of a heater

Sometimes, the radiator gives hot air only the first several seconds after turning on of the fan of a heater, and then air remains hardly warm. Malfunction can be caused by the shift of a rubber partition which divides a tank into two parts. For check we merge cooling liquid from the cooling system. We put the radiator removed from the car vertically, branch pipes down. We connect a hose with water from a water supply system to one of branch pipes and slowly we start up a stream. On a faulty radiator water will at once run from other branch pipe. The serviceable radiator will be filled, considerably will grow heavy, and only then water will begin to flow from other branch pipe.