22.8. Removal and dismantling of forward and back bumpers and towing eyes

 PERFORMANCE ORDER

For removal of a front bumper we remove a plate of protection of a subdale of a case and a mudguard.

Head "on 22" we turn off a bolt of fastening of a towing eye and a connector of a bumper to the left forward longeron.

We remove an eye and a bolt.

Similarly we disconnect fastening of a towing eye and connector of a bumper to the right longeron.

Shaking, we extend bumper connectors from sealants of the lower cross-piece of a front.

Having hooked the screw-driver, …

… we take out a rubber sealant from an opening of the lower cross-piece.

For removal of a rear bumper …

... a head "on 22" we turn off a bolt of fastening of a connector of a bumper to the right back longeron …

… also we take out a bolt.

Similarly we turn off a bolt of fastening of a connector of a bumper to the left back longeron. And rubber a sealant we remove a rear bumper the same as lobbies.
For removal of back towing eyes …

... a head "on 17" we turn off two bolts …

… also we remove an eye.

Forward and back bumpers understand equally – we show on the example of forward.
For dismantle of a connector …

... a head "on 13" we turn off two nuts …

… also we remove a connector.

For removal of a side plastic slip …

… by the crosswise screw-driver it is turned off four self-tapping screws …

… also we remove a slip.

For removal of a rubber slip …

… a head "on 8" we turn off four nuts …

… also we remove a slip.

For removal of a metal arm …

… a head "on 13" we turn off two nuts, holding bolts a key of the same dimension, …

… also we remove an arm.

We collect and establish a bumper in the return sequence.