22:24. Removal of a door of a back

 PERFORMANCE ORDER

We disconnect the back door glass cleaner electric motor socket (see back door glass cleaner Removal).
We mark position of plugs in a block.

By the thin shlitsevy screw-driver it is hooked …

… also we release plugs from a block.

We tie a wire piece to a bunch of wires of the electric motor of a cleaner of back glass and illumination of registration plate.

On the left side of a door we disconnect the socket of heating of back glass …

… also we extend a bunch of wires.

We untie a wire piece from a bunch, having left a wire in a door cavity for the subsequent drawing of a bunch of wires.

We disconnect a back door washer tube …

… also we extend a tube from a door cavity.
We disconnect a gas-filled emphasis from a back door (see Removal of a gas-filled emphasis of a door of a back).
The assistant holds a door.

Head "on 10" we turn off two nuts of fastening of the right loop to a back door …

… and two nuts of fastening of the left loop.

We remove a back door.

Connection of a loop and door is condensed with rubber laying.

For replacement of a loop of a door of a back …

… we remove a sealant in the top corner of a door.

In salon in the top corner …

… the crosswise screw-driver we unscrew the self-tapping screw of fastening of an upholstery of a back rack.

By the Shlitsevy screw-driver it is hooked and we remove two brackets of fastening of an upholstery of a ceiling to a body.

We remove an upholstery of a ceiling and a head "on 10" we turn off two nuts of fastening of a loop to a body.

We remove a loop …

… and the rubber laying condensing connection of a loop with a body.

We establish loops and a door upside-down, having replaced sealing laying with new. Finally we tighten nuts of fastening of a loop to a body, having convinced of the correct arrangement of a door in a body aperture.