22:15. Removal of the mechanism of a window regulator of a door

 PERFORMANCE ORDER

The mechanism of a window regulator is removed for its replacement or at full dismantling of a door.
We remove a door upholstery (see Removal of an upholstery of a door).
We disconnect fastening of a cable of a window regulator to forward and back holders of glass (see door glass Replacement).
We lift glass hands …

… also we fix it from falling by the screw (or a hairpin) with M5 carving screwed in an opening of the forward holder of glass.

Head "on 8" we turn off three nuts of fastening of the mechanism of a window regulator to the internal panel of a door.

We bring the window regulator mechanism to a window in the door panel.

If we do not replace the mechanism of a window regulator, and we remove at full dismantling of a door, …

… we connect that by a cable branch wire near the window regulator reel of the mechanism.

We lower glass hands to the rubber buffer (see door glass Replacement).
We remove a cable from four rollers …

… also we take out the window regulator mechanism with a cable.

Head "on 10" we turn off a bolt of fastening of an arm of a tension roller …

… also we take out an arm with a roller.

At assembly, having established an arm of a tension roller, we do not tighten a bolt of its fastening.
Having lifted glass, we fix it.

We pass a window regulator mechanism shaft throughout an opening of the internal panel of a door (the new mechanism of a window regulator is on sale with the connected branches of a cable).

We put on a cable rollers according to the scheme.

Bokorezami is had a bite the wire fixing cable branches.

We pass window regulator mechanism hairpins throughout openings and we fix the mechanism.
For a cable tension slightly we tighten a bolt of an arm of a tension roller.

Tapping with the hammer on the head extender "on 10", put on an arm bolt, …

… we displace a roller down, pulling a cable. Finally we tighten a bolt.
Nazhivlyaem screws of two clamping levels of arms of a holder of glass and we tighten screws of a level of a forward arm a little.
We rotate counterclockwise the handle which is put on a window regulator mechanism shaft till the moment until rotation of the drum of the mechanism of a window regulator stops. We lift glass hands against the stop and, holding it in this situation, we turn the handle which is put on a window regulator mechanism shaft clockwise half way.

The crosswise screw-driver through a window in the top part of the internal panel of a door finally we tighten screws of a level of a forward arm of a holder of glass.

We lower glass to that level when through a window of the internal panel of a door it is possible to tighten screws of a level of a back arm of a holder of glass (see Replacement of glass of a forward door).
Having checked operation of the mechanism of a window regulator, we grease a cable and rollers with Litol-24 lubricant.