20.3. Replacement of front brake shoes

 PERFORMANCE ORDER

We hang out and remove a forward wheel.

Passatizhami we take out the forelock of the lower axis of the clamping lever.

Drift we move an axis of the clamping lever …

… and, holding the lever, passatizham we take out an axis.

We remove clamping the lever.

We take out from directing blocks two springs of the clamping lever that not to lose them.

Having hooked the screw-driver, we lift a brake support …

… also we put on a rotary fist.

We take brake shoes from a guide.

Before installation of new brake shoes it is necessary to move pistons as it is possible further in cylinders.

Sliding passatizha (or an alligator wrench) we press pistons into cylinders.

It is possible to drown pistons in cylinders and in a different way. For this purpose we insert an external block into a guide and, having established a support into place, …

… an assembly shovel we press pistons into cylinders.

Further the knot is collected in the return sequence.
For simplification of installation of an axis of the clamping lever …

… on sharpened its tip so is sharpened, …

… that the cone turned out.

Before installation we grease an axis of the clamping lever with graphite lubricant.

Having pressed the lever, we insert an axis.

After installation of brake shoes it is necessary to press a brake pedal that pistons of cylinders brought blocks to a brake disk several times.