20:15. Adjustment and removal of knots of the parking brake system

 PERFORMANCE ORDER

If the parking brake system does not hold the car on a bias to 25% when moving the lever of the drive of 4–5 teeths of the ratchet device, the parking brake it is necessary to adjust.

We install the car on a viewing ditch or the elevator.

We hang out a back axis of the car and we lower the lever of the drive of the parking brake in the lower situation.

Holding an adjusting nut with a key "on 13", the same key we weaken a lock-nut.

Holding a tip of a cable of a passatizhama, a key "on 13" we tighten an adjusting nut.

It is possible to hold a tip of a cable and in the place of its connection with a spring, having clamped its end of a passatizhama.
At the same time the full speed of the lever of the drive of the parking brake has to make 4–5 teeths of the sector of the ratchet device. At completely lowered lever of a wheel have to rotate freely, without jamming. In this situation we tighten a lock-nut.
For removal of a forward cable and the lever of the drive of the parking brake system we lower the lever in the lower situation.

We remove an ottyazhny spring.

Two keys "on 13" raskont-rivay nuts.

Holding passatizham a tip of a forward cable, a high head "on 13" at the same time we turn off an adjusting nut and a lock-nut.

We remove the expansion plug from a tip of a forward cable.

We remove a guide of a back cable.

Passatizhami we take out the forelock, …

… we remove a persistent washer …

… also we disconnect a forward cable from the lever of the drive of the parking brake.

In salon the crosswise screw-driver we unscrew the screw of side fastening of a casing of the lever …

… and self-tapping screw of back fastening.

We remove a lever casing.

We remove sealing laying.

Head "on 10" we turn off four bolts of fastening of an arm of the lever to a floor.

We remove the lever of the drive of the parking brake.

For removal of a back cable of the drive of the parking brake system we disconnect its tips from levers of the manual drive of back blocks (see Replacement of back brake shoes).
We remove a guide of a back cable.

We shift a protective rubber cap from a cable cover tip.

The screw-driver we shift a cable cover tip …

… also we bring him out of a body arm opening.

Passatizhami is unbent an eye of an arm of a beam of the back bridge …

… also we remove a cable.

Key "on 10" we turn off two bolts of fastening of the holder of a cover of a cable to a brake board.

We bring a cable tip out of an opening of a brake board.

In the same way we release other end of a back cable.

We remove a back cable of the drive of the parking brake system.

We establish a cable in the return sequence. We adjust the parking brake system.